Enterasys Networks X-Pedition XSR CLI - Manual (Page 221)

Policy-Based Routing Commands
XSR CLI Reference Guide 5-145
Syntax of the “no” Form
The no form of this command disables triggered RIP on the interface:
no ip rip triggered-on-demand
Mode
Interface configuration: XSR(config-if<xx>)#
Default
Disabled
Example
The following example configures triggered RIP on Serial port 1/0:
XSR(config)#interface serial 1/0
XSR(config-if)#ip address 1.0.0.0 255.0.0.0
XSR(config-if)#no shutdown
XSR(config-if)#ip rip triggered-on-demand
XSR(config-router)#network 1.0.0.0
Policy-Based Routing Commands
Policy‐Based Routing (PBR) on the XSR.
ip policy
This command applies PBR to XSR Fast/GigabitEthernet, Dialer, Loopback, Multilink, VPN and
Serial interfaces.
Syntax
ip policy
Syntax of the “no” Form
The no command negates PBR on XSR interfaces:
no ip policy
Mode
Interface configuration: XSR(config-if)#
Default
Disabled