Enterasys Networks X-Pedition XSR CLI - Manual (Page 443)

Dialer Interface Commands
XSR CLI Reference Guide 10-89
XSR(config-if)#dialer-group 7
XSR(config-if)#access-list 101 permit ip 0.0.0.0 255.255.255.255 255.255.255.255
0.0.0.0
XSR(config)#dialer-list 7 protocol ip list 101
map-class dialer
This command defines the dial stringʹs characteristics and associates them with a unique class
name. Once the
map-class dialer classname command is executed the parameters assigned to
that classname must be configured. The classname assigned must match the classname assigned to
the dialer string class classname so they can be linked.
Syntax
map-class dialer classname
Default
None ‐ no class name
Mode
Global configuration: XSR(config)#
Next Mode
Map‐Class Dialer configuration: XSR(config-map-class<xx>)#
Example
The example below specifies a 90‐second wait time for the carrier signal of the dialer map class
TEST on Dialer port 0:
XSR(config)#interface dialer 0
XSR(config-if)#ip address 196.16.25.1 255.255.255.0
XSR(config-if)#encapsulation ppp
XSR(config-if)#dialer remote-name sitea
XSR(config-if)#dialer string 4165555584 class TEST
XSR(config-if)#dialer pool 1
XSR(config-if)#no shutdown
XSR(config)#map-class dialer 57
XSR(config-map-class<57>)#dialer wait-for-carrier-time 90
modem-init-string
This command sets an AT command string used to initialize a modem.
Syntax
modem-init-string word
classname Unique class identifier.
word Text to initialize the modem.