Enterasys Networks X-Pedition XSR CLI - Manual (Page 414)

Frame Relay Commands
9-90 Configuring Frame Relay
Default
3
Mode
Interface configuration: XSR(config-if<xx>)#
Example
This example sets the LMI failure threshold to 5 for the DCE device:
XSR(config)#interface serial 1/0
XSR(config-if)#encapsulation frame-relay
XSR(config-if)#frame-relay intf-type dce
XSR(config-if)#frame-relay lmi-n392dce 5
frame-relay lmi-n392dte
This command sets the error threshold on a Data Terminal Equipment (DTE) interface.
Syntax
frame-relay lmi-n392dte threshold
Syntax of the “no” Form
Use the no command to remove the current setting:
no frame-relay lmi-n392dte
Default
3
Mode
Interface configuration: XSR(config-if<xx>)#
Example
The following example sets the LMI failure threshold to 5 for the DTE device:
XSR(config)#interface serial 1/0
XSR(config-if)#encapsulation frame-relay
XSR(config-if)#frame-relay intf-type dte
XSR(config-if)#frame-relay lmi-n392dte 5
threshold Error threshold, ranging from 1 to 10.