Enterasys Networks X-Pedition XSR CLI - Manual (Page 339)

PIM Commands
XSR CLI Reference Guide 7-91
ip pim dr-priority
This command sets the priority for which a router is elected as the Designated Router (DR).
Syntax
ip pim dr-priority priority-value
Syntax of the “no” Form
The no form of this command disables the DR functionality:
no ip pim dr-priority
Mode
Interface configuration: XSR(config-if)#
Defaults
• DR functionality is disabled on the interface
• DR‐priority: 1
Example
The following example sets the DR priority value of F1 to 20:
XSR(config-if)#ip pim dr-priority 20
ip pim message-interval
This command configures the frequency at which a Protocol Independent Multicast Sparse Mode
(PIM‐SM) router sends periodic join and prune messages.
Syntax
ip pim message-interval seconds
Syntax of the “no” Form
The no form of this command sets the interval to the default value:
no ip pim message-interval
Mode
Interface configuration: XSR(config-if)#
priority-value Preference value, ranging from 0 to 4294967294, to set the priority of the
router for selection as the DR.
seconds Interval to send periodic PIM‐SM join and prune messages. Range: 1 to 65535.