Enterasys Networks X-Pedition XSR CLI - Manual (Page 56)

SLA Agent Commands
1-42 Network Management
Syntax of the “no” Form
The no form of this command returns to the default value:
no timeout
Mode
RTR Echo configuration: XSR(config-rtr-echo-xx)#
Default
5000 milliseconds
Example
The following example resets the RTR timeout to 500 milliseconds:
XSR(config-rtr-echo-57)#timeout 500
type
This command specifies the type of Response Time Reporter (RTR) measurement to be performed
‐ ICMP Echo ‐ as well as the destination and source host IP addresses.
Syntax
type {echo} protocol {ipIcmpEcho} dst [source-ipaddr src]
Mode
RTR configuration: XSR(config-rtr-xx)
Next Mode
RTR Echo configuration: XSR(config-rtr-echo-xx)
Example
The following example sets the RTR type and acquires RTR Echo mode:
XSR(config-rtr-57)#type echo protocol ipIcmpEcho 192.168.57.3
XSR(config-rtr-echo-57)
dst IP address of the destination host.
src IP address used as the source.