Enterasys Networks X-Pedition XSR CLI - Manual (Page 453)

DOD/BOD Commands
XSR CLI Reference Guide 10-99
Syntax of the “no” Form
The no form of this command disables the feature:
no dialer caller number
Mode
Dialer Interface configuration: XSR(config-ifx>)#
Example
The following example configures the dialer caller numbers to screen:
XSR(config)#interface dialer 1
XSR(config-if)#dialer caller 5084712345
dialer idle-timeout
This command specifies the idle timeout interval before the XSR disconnects the line. The timeout
trigger is based on outbound traffic only.
Syntax
dialer idle-timeout seconds
Syntax of the “no” Form
Use the no form of this command to reset the idle timeout to the default:
no dialer idle-timeout
Mode
Dialer Interface configuration: XSR(config-ifx>)#
Default
120 seconds
Examples
The following example resets the idle‐timeout:
Note: If the ISDN switch does not provide the calling number, callback will fail.
Caution: This command must be invoked on the called side of a link with a 0 value to ensure the
link is not dropped after 120 seconds by the called side.
seconds Interval before disconnecting the line, ranging from 0 to 2,147,483 seconds.
Specifying 0 disables the timeout.