Enterasys Networks X-Pedition XSR CLI - Manual (Page 264)

Network Address Translation Commands
5-188 Configuring the Internet Protocol
Syntax of the “no” Form
The no form of the command removes a single static translation entry:
no ip nat source static local-ip global-ip
Mode
Global configuration: XSR(config)#
Example
The following example configures a static NAT system:
XSR(config)#ip nat source static 192.178.15.97 10.10.10.5
ip nat translation
This command changes the interval after which translations time out.
Syntax
ip nat translation {timeout | udp-timeout | tcp-timeout | icmp-timeout}[seconds]
| [never]
Syntax of the “no” Form
The no command configures default timeout values:
no ip nat translation {timeout | udp-timeout | tcp-timeout | icmp-timeout}
[seconds] | [never]
Mode
Global configuration: XSR(config)#
global-ip Translated IP address.
tcp | udp This value implies that his is a port‐specific static NAT.
local-port Source port of outgoing packets and destination port of incoming packets.
global-port Destination port of outgoing packets and source port of incoming packets.
timeout Dynamic NAT interval (not overload translations).
udp-timeout UDP port interval.
tcp-timeout TCP port interval.
icmp-timeout ICMP traffic interval.
seconds Period after which port translation expires.
never No expiration.