Enterasys Networks X-Pedition XSR CLI - Manual (Page 217)

RTP Header Compression Commands
XSR CLI Reference Guide 5-141
show ip rtp header compression interface serial
This command displays the RTP header compression statistics for the specific PPP serial interface.
Note: The existing command “show ppp interface serial” has been updated to add the following
line in the PPP stats section “TX/RX IP Header Compression (IPHC is enabled” if IP header
compression has been negotiated with the remote peer. See
page 8‐102 for information on the
command “show ppp interface serial”.
Syntax
show ip rtp header-compression interface serial slot/port{.sub-interface}
Mode
Privileged EXEC: XSR
Example
The following example displays the RTP Statistics for serial interface 2/0:1
Router# show ip rtp header‐compression interface serial 2/0:1
RTP/UDP/IP Header compression statistics:
Interface Serial 2/0:1
Active/Negotiated connections: RX = 0/0 TX = 0/0
Rcvd:
Compr. RTP = 0 Compr. UDP = 0 Full Header = 0
Error = 0 Dropped = 0 Total Pkts = 0
Bytes rcvd = 0 Bytes Saved = 0 Efficiency Improve = 0.00
Send:
Compr. RTP = 0 Compr. UDP = 0 Full Header = 0
Rej. IP = 0 Rej. Non RTP = 0 Total Pkts = 0
Bytes sent = 0 Bytes Saved = 0 Efficiency Improve = 0.00
Misses = 0 hit Ratio = 0%
Parameter Descriptions
slot/port{.sub-interface The slot, port and sub‐interface this command is to be applied
to.
Interface Serial Type and number of interface.
Active/Negotiated
connections: Number of active and Negotiated RTP connections.