Enterasys Networks X-Pedition XSR CLI - Manual (Page 526)

PPP Configuration Commands
13-100 Configuring ADSL
Syntax of the “no” Form
The no form of this command returns this parameter to its default setting:
no ppp keepalive
Mode
ATM Sub‐Interface configuration: XSR(config-ifx/x/x.x>)#
Defaults
• Disabled
• Keepalive period: 30 seconds
Example
This example enables the keepalive mechanism and sets the time between messages to 20 seconds:
XSR(config-if)#ppp keepalive 20
ppp lcp
This command configures Link Control Protocol (LCP) parameters for PPP. It requires a properly
configured ATM sub‐interface specifying encapsulation type PPPoA or PPPoE.
Syntax
ppp lcp {max-configure <count1> | max-failure <count2> | max-terminate <count3>}
Syntax of the “no” Form
The no form of this command returns this parameter to its default setting:
no ppp lcp
Mode
ATM Sub‐Interface configuration: XSR(config-ifx/x/x.x>)#
Defaults
• Configure‐Requests: 10
• Configure‐Nak: 5
• Terminate‐Requests: 2
max-configure count1 Peak number of Configure‐Requests to send. Range: 1 to 255.
max-failure count2 Peak number of Configure‐Nak packets to send. Range: 1 to 255.
max-terminate count3 Peak number of Terminate‐Requests to send. Range: 1 to 255.