Enterasys Networks X-Pedition XSR CLI - Manual (Page 674)

Firewall Interface Commands
16-130 Configuring Security
Example
The following example disables the firewall on FastEthernet port 2 only:
XSR(config-if)#ip firewall disable
ip firewall ip-broadcast
This command allows incoming/outgoing IP packets through the firewall with 255.255.255.255 set
as the destination address. It enables broadcast protocols such as DHCP to traverse the firewall.
Syntax
ip firewall ip-broadcast {in | out | both}
Syntax of the “no” Form
The no form of this command denies the selected broadcast packets:
no ip firewall ip-broadcast {in | out | both}
Default
IP broadcast packets are not allowed inbound and outbound.
Mode
Interface configuration: XSR(config-if)#
Example
The example below allows broadcast filtering on outgoing packets only:
XSR(config-if)#ip firewall ip-broadcast out
ip firewall ip-multicast
This command allows incoming/outgoing IP packets with a multicast destination address through
the firewall. It enables multicast protocols such as RIP and OSPF to traverse the firewall.
Syntax
ip firewall ip-multicast {in | out | both}
Syntax of the “no” Form
The no form of this command denies the selected multicast packets:
in or out Allows packets to enter or exit the interface.
both Allows packets to enter and exit the interface.
in or out Allows packets to enter or exit the interface.
both Allows packets to enter and exit the interface.