Enterasys Networks X-Pedition XSR CLI - Manual (Page 446)

Dialer Interface Clear and Show Commands
10-92 Configuring the Dialer Interface
Phone numbers: <2400:12>
Connection speed/type: <64k>/
Dialer maps configured on Interface :
Next hop IP address: <20.20.20.2>
Phone numbers: <2400>
Connection speed/type: /
show dialer sessions
This command displays information regarding dialer sessions.
Syntax
show dialer sessions
Mode
EXEC: XSR#
Sample Output
The following is sample output from the show dialer sessions command:
XSR#show dialer sessions
ID
Interface Type State MLPPP Phone# Phys Intf
0001 Dialer1 On Demand IDLE 001
0002 Dialer1 Multilink CONNECTED 001 3100 Serial 2/0:30
0003 Dialer1 Incoming CONNECTED 001 Serial 2/0:12
0004 Dialer0 On Demand WAITING 000 2600 D-Serial 1/0:0
Parameter Descriptions
ID Dial session ID number ‐ node‐wide and unique. Range: 1 to 512.
Interface Dialer interface number which has requested the dial session.
Type Dial session type:
• On demand: session that handles on demand connection requests
• Backup: session which is requested by a backed up interface or
watched route
• Multilink: dial session requested by a multilink group used for
backup or on demand
• Callback: dial callback session.
• Bandwidth: a Bandwidth on Demand requested connection.
State IDLE, WAITING, CALLING or CONNECTED.
MLPPP MLPPP group number to which the dial session belongs.
Phone No Number used to dial out.
Phys Intf Dialer pool port used to build a switched link with remote peer.