Enterasys Networks X-Pedition XSR CLI - Manual (Page 157)

Hardware Controller Clear and Show Commands
XSR CLI Reference Guide 4-105
Sent: 0 octets, 0 unicast packets,
0 discards, 0 errors.
MTU is 1500 bytes.
Proxy ARP is enabled.
Helper address is not set.
Directed broadcast is enabled.
Outgoing access list is not set.
Inbound access list is not set.
IP Policy Based Routing is not enabled.
The following example is sample output from the show interface null 0 command:
XSR#show interface null 0
Null0 is Admin Up
Internet address is not assigned
show interface serial
This command displays general information for a serial interface.
Syntax
show interface serial [card/port]
Mode
Privileged EXEC or Global configuration: XSR# or XSR(config)#
Sample Output
The following example displays output from Serial interface 1/0:
XSR#show interface serial 1/0
********** Serial Interface Stats **********
Serial 1/0 is Admin Down / Oper Down
Internet address is 200.163.21.1
The name of this device is Ser1/0.
The card is 1.
The channel is 0.
The current MTU is 1500.
The device is in polling mode, and is ACTIVE.
The last driver error is (null).
The physical-layer is HDLC-SYNC.
The baud rate is estimated to be 1024000 bits/sec.
The device uses CRC-16 for Tx.
The device uses CRC-16 for Rx.
The type of encoding is NRZ.
The media-type is RS-232/V.28 (DTE).
The loopback mode is off.
Other Interface Statistics:
card XSR card number of serial interface.
port XSR port number of serial interface.