Enterasys Networks X-Pedition XSR CLI - Manual (Page 348)

IGMP Clear and Show Commands
7-100 Configuring IP Multicast
Example
The following example displays sample responses:
XSR>#show ip pim bsr
PIMv2 Bootstrap information
This system is the Elected Bootstrap Router (BSR)
BSR address: 192.168.27.1
Uptime: 04:37:46, BSR Priority: 4, Hash mask length: 30
Next bootstrap message in 00:00:03 seconds
This system is the Candidate Bootstrap Router (CBSR)
Candidate BSR Address: 50.0.0.30 Priority: 0, Hash Mask Length: 30
Parameters in the Response
show ip pim interface
This command displays data about interfaces set for Protocol Independent Multicast (PIM).
Syntax
show ip pim interface [type number]
Mode
EXEC configuration: XSR>
Example
The following example display sample responses:
XSR>show ip pim interface
PIM Interface Table
Address Interface Nbr
Count Hello Intvl DR
30.0.0.20 FastEthernet1 0 30 30.0.0.20
40.0.0.20 FastEthernet2 2 30 40.0.0.40
BSR address IP address of the bootstrap router.
Uptime Interval that this XSR has been up, in hours:minutes:seconds.
BSR Priority Priority as set by the ip pim bsr-candidate command.
Hash mask length Length of a mask (32 bits maximum) that is to be ANDed with the
group address before the hash function is called. This value is
configured by the
ip pim bsr-candidate command.
Next bootstrap message in Period (in hours:minutes:seconds) in which the next bootstrap
message is due from this BSR.
type Interface type.
number Interface number.