Enterasys Networks X-Pedition XSR CLI - Manual (Page 95)

Other Platform Commands
XSR CLI Reference Guide 3-89
Syntax of the “no” Form
Use the no form of this command to disable the earlier configured service:
no logging [console | buffered | monitor | snmp | A.B.C.D | file | timestamp]
Mode
Global Configuration: XSR(config)#
Defaults
• File: off
• A.B.C.D.: 0.0.0.0 (no messages sent until an IP address is set)
• Logging level: High for all destinations
User Guidelines
The table below displays standard syslog error message types and definitions.
The XSR recognizes messages at four levels, described in the table below:
medium Sets system log to Medium level.
low Sets system log to Low level.
debug Sets system log to Debug level.
timestamp Sets time and date.
local Sets timestamp to local time.
utc Sets timestamp to the Universal Time Clock.
Message Type Definition
0: Emergency System is unusable
1: Alert Action must be taken immediately
2: Critical Critical conditions
3: Error Error conditions
4: Warning Warning conditions
5: Notice Normal but signification condition
6: Info Informational
7: Debug Debug-level messages
8: Security Security related messages
Priority Code = Facility Code *8 + Severity
Severity User Level Message
(Facility = 1) Security/Auth Message
(Facility = 10)
High, severity = 2 (Critical) 10 82
Med, severity = 3 (Error) 11 83
Low, severity = 4 (Warning) 12 84