Enterasys Networks X-Pedition XSR CLI - Manual (Page 21)

General Network Management Commands
XSR CLI Reference Guide 1-7
• Port number 22
Example
XSR(config)#ip ssh server enable
ip telnet port
This command changes the Telnet port where incoming Telnet sessions connect to.
Syntax
ip telnet port {port_number | default}
Mode
Global configuration: XSR(config)#
Default
Port number: 23
Examples
XSR(config)#ip telnet port 5678
ip telnet server
This command enables or disables Telnet service to the XSR. If the optional parameter is not
supplied, the Telnet server is enabled.
Since the Telnet server is enabled at boot‐up, you must either manually disable it using the CLI or
disable it in
startup-config .
Syntax
ip telnet server [enable | disable]
Syntax of the “no” Form
The no form of this command disables the Telnet server:
no ip telnet server
port_number Incoming Telnet server port number from 1024 to 65535.
default Sets the Telnet port to the default.
Note: If you try to set the port-number but it is already in use (the Web, e.g.) , it will be reset to the
default value automatically.
enable Enables Telnet service.
disable Disables Telnet service.