Copy Page 114
Page 114
File System Commands
3-108 Configuring the XSR Platform
XSR(config)#rename VPN_XSR1800.fls xsr1800.fls
Rename flash:VPN_xsr1800.fls to flash:xsr1800.fls(y/n) ? y
renaming file flash:VPN_xsr1800.fls -> flash:xsr1800.fls
XSR#
The following example renames the firmware file as part of an FTP/TFTP transfer. After entering
the command, you are prompted by this script:
XSR-1800#copy tftp://192.168.37.162/c:\firmware\VPN_xsr1800.fls flash:xsr1800.fls
Copy 'c:\firmware\VPN_xsr1800.fls' from server as 'xsr1800.fls' into Flash(y/n) ? y
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Download from server done
File size: 3242460 bytes
XSR-1800#
cd
This command changes the current directory to
flash:
or
cflash:
on the XSR file system.
Syntax
cd [flash: | cflash:]
Mode
Privileged EXEC:
XSR#
Example
XSR#cd cflash:
copy
This command copies a file to a new file which may reside in a local directory,
flash:
or
cflash:
,
or on a remote TFTP server. You can omit the destination filename if new and source file names
are identical. The XSR’s MS‐DOS‐compatible file system of On‐Board Flash (
flash:
) or
CompactFlash (
cflash:
) memory.
Copy
initiates a script prompting your confirmation.
Syntax
copy source destination
The possible options are:
XSR#copy {flash:| cflash:}[filename]{flash:| cflash:}[filename]
XSR#copy {flash:| cflash:}[filename] tftp: [[[// location]/directory]/filename]
XSR#copy tftp: [[[//location]/directory]/filename]{flash: cflash:}[filename]
flash:
Default directory in Flash memory.
cflash:
Default directory in CompactFlash memory.