Enterasys Networks X-Pedition XSR CLI - Manual (Page 205)

RIP Commands
XSR CLI Reference Guide 5-129
Figure 5-3 Offset Example
ip rip receive version
This command sets RIP v1 or v2 for update packets received on the port.
Syntax
ip rip receive version [1] [2]
Syntax of the “no” Form
The no form of this command restores the default version of the RIP module update packets that
are accepted on the interface:
no ip rip receive version
Mode
Interface configuration: XSR(config-if<xx>)#
Default
Accept both RIP version 1 and 2
Example
This example sets both RIP versions 1 and 2 for update packets received on FastEthernet port 1:
XSR(config)#interface fastethernet 1
XSR(config-if)#ip rip receive version 1 2
Serial 1/1
Backup
Distance Router 1-Router x2+1 hops
Router x
Router 1
INTERNET
INTERNET
Distance Router1-Rx2 hops
Serial 1/0
1 RIP version 1.
2 RIP version 2.