Enterasys Networks X-Pedition XSR CLI - Manual (Page 596)

DHCP Commands
15-86 Configuring DHCP
Example
The following example specifies the client identifier for MAC address 00.01f4.0127.10 in dotted
hexadecimal notation:
XSR(config-dhcp)#client-identifier 0100.01f4.0127.10
The following example specifies the client identifier for MAC address 0001.f401.2710 in dotted
hexadecimal notation, for the host with IP address 10.10.10.20:
XSR(config-dhcp-pool)#host 10.10.10.20 255.255.255.0
XSR(config-dhcp-host)#client-identifier 0100.01f4.0127.10
The following example specifies the client identifier for MAC address 00.01f4.0127.10 in dotted
hexadecimal notation, and adds it to class eng:
XSR(config-dhcp-pool)#client-class eng
XSR(config-dhcp-class)#client-identifier 0100.01f4.0127.10
client-name
This command specifies the name of a DHCP client. The client name should not include the
domain name. The command is available from DHCP host mode only.
Syntax
client-name name
Syntax of the “no” Form
Use the no form of this command to remove the client name:
no client-name name
Mode
DHCP host configuration only: XSR(config-dhcp-host)#
Example
The following example specifies a string soho1 that will be the name of the client with MAC
address 1111.2222.3333:
XSR(config-dhcp-pool)#hardware-address 1111.2222.3333
XSR(config-dhcp-host)#client-name soho1
name Designation of the client, defined using any set of standard ASCII characters. The client
name should not include the domain name. For example, the name soho should not be
specified as soho.enterasys.com.