Enterasys Networks X-Pedition XSR CLI - Manual (Page 185)

OSPF Debug and Show Commands
XSR CLI Reference Guide 5-109
show ip ospf
This command, when any debugging type is enabled, displays output about the following types
of OSPF information: designated router events, neighbor events, Link State Advertisements
(LSAs), and packets.
Syntax
show ip ospf
Mode
EXEC or Global configuration: XSR> or XSR(config)#
Sample Output
The following is sample output when all debugging types are enabled:
XSR#show ip ospf
Routing Process "ospf 1 " with ID 1.1.1.4
Supports only single TOS(TOS0) route
It is an area border and autonomous system boundary router
Summary Link update interval is 0 seconds.
External Link update interval is 0 seconds.
Debugging enabled for:
dr
lsa
nbr
packet
Redistributing External Routes from:
static
Number of areas in this router is 4
Area BACKBONE (0)
Number of interfaces in this area is 1
Area has no authentication
SPF algorithm executed 2 times
Area ranges are
Area 0.0.0.5
Number of interfaces in this area is 2
Area has no authentication
SPF algorithm executed 2 times
Area ranges are
18.0.0.0 255.0.0.0
Parameter Descriptions
Routing Process OSPF process number and router ID.
Supports TOS support.