Enterasys Networks X-Pedition XSR CLI - Manual (Page 69)

T1/E1 & T3/E3 Commands
XSR CLI Reference Guide 2-63
XSR(config)#controller t1 1/0
XSR(config-controller)#framing esf
XSR(config-controller)#linecode b8zs
XSR(config-controller)#clock source line
XSR(config-controller)#description “Acme’s T1”
The following example describes the T3 controller in slot 1, card 2:
XSR(config)#controller t3 1/2
XSR(config-controller)#description “T3 Up at ACME”
dsu mode
For T3/E3 un-channelized controllers only
This command configures an unchannelized sub‐rate T3/E3 port to emulate a proprietary Data
Service Unit (DSU) scheme. The XSR supports interoperability with a wide range of third‐party
DSU vendors.
Local DSU mode configuration must match the remote configuration, so you must know what
type of DSU is connected to the remote port to determine if it interoperates with a T3 or E3 NIM.
This command enables interoperability with providers using various T3 or E3 DSUs to provision
the T3/E3 line.
Syntax
dsu mode {digitallink | kentrox | larscom | adtran | verilink}
Syntax of the “no” Form
The no form of this command sets the DSU mode to the default value:
no dsu mode
Mode
Controller configuration: XSR(config-controller xx)#
Example
The following example configures the T3 controller in slot 1, card 2 with line source clocking, M13
framing, in unchannelized mode, with a cable length of 250 feet, and DSU interoperability mode
set to an Adtran DSU:
XSR(config)#controllerXSR(config-controller)#no channelized
XSR(config-controller)#clock source line
digitallink Digitallink mode connects the T3/E3 controller to a Digital Link, CISCO,
or Quick Eagle DSU.
kentrox Kentrox mode connects the T3/E3 controller to a Kentrox DSU.
larscom Larscom mode links the T3 controller to a Larscom DSU.
adtran Adtran mode connects the T3 controller to an Adtran T3SU 300.
verilink Verilink mode connects the T3 controller to a Verilink HDM 2182.