Enterasys Networks X-Pedition XSR CLI - Manual (Page 445)

Dialer Interface Clear and Show Commands
XSR CLI Reference Guide 10-91
Example
XSR#show dialer 1
Sample Output
The following is sample output from the show dialer command for a dialer interface:
#show dialer 5
Dialer5
Dialer state is: UP
Wait for carrier default: 60, default retry: 3
Dial String Success Failures Map Class
3200 2 0
Dialer pool 23
(Serial 2/0:0, )
Parameter Descriptions
show dialer maps
This command displays dialer policies.
Syntax
show dialer maps
Mode
EXEC: XSR#
Sample Output
The following is sample output from the show dialer maps command:
Dialer maps configured on Interface :
Next hop IP address: <10.10.10.2>
Remote host:
Map class:
Dialer1 Name of the dialer interface.
Wait for carrier(30 secs) Seconds to wait for carrier signal.
Default retry Number of default call retries.
Dial String Dial strings to used to make calls.
Successes Number of successful connections.
Failures Failed Connections.
Map Class Name of associated map class.
Dialer pool 2, priority 0 Indicates that this interface is a member of dialer pool 2 with a priority
of 0 in that pool.
Serial0 Type of interface.