Enterasys Networks X-Pedition XSR CLI - Manual (Page 474)

ISDN Debug and Show Commands
11-96 ISDN BRI and PRI Commands
Standard output of the command follows but is not displayed here.
The following output is displayed for the BRI interface 2/1:
XSR#sh interface bri 2/1
********** Serial Interface Stats **********
D-Serial 2/1:0 is Admin Down / Oper Down
********************** ISDN Stats ISDN-BRI 2/1 *******************
Layer 1: DOWN Layer 2: DOWN State: OFFLINE Admin Down Oper Down
The name of this device is bri2/1/0.
The card is 2.
The port is 1.
The channel is 0.
The current MTU is 1506.
The device is in polling mode, and is INACTIVE.
The channel is logically INACTIVE.
The operational state is OPER_DOWN.
The protocol used is LAPD.
The baud rate is 16000 bits/sec.
The device uses CRC-16 for Tx.
The device uses CRC-16 for Rx.
Other Interface Statistics:
ifindex 0
ifType 75
ifAdminStatus 1
ifOperStatus 2
ifLastChange 00:00:00
ifInOctets 0
ifInUcastPkts 0
ifInNUcastPkts 0
ifInDiscards 0
ifInErrors 0
ifInUnknownProtos 0
ifOutOctets 0
ifOutUcastPkts 0
ifOutNUcastPkts 0
ifOutDiscards 0
ifOutErrors 0
ifOutQLen 16