Enterasys Networks X-Pedition XSR CLI - Manual (Page 364)

PPP Commands
8-94 Configuring the Point-to-Point Protocol
Syntax
ppp peer default ip address {ip address}
Syntax of the “no” Form
Use the no form of this command to remove the IP address:
no ppp peer default ip address
Mode
Interface configuration: XSR(config-if<xx>)#
Examples
This example sets the peer’s IP address on Serial interface 1/0:
XSR(config)#interface serial 1/0
XSR(config-if)#encapsulation ppp
XSR(config-if)#ppp peer default ip address 192.168.1.3
This example sets the peer’s IP address on P2P Dialer interface 1:
XSR(config)#interface dialer 1
XSR(config-if)#encapsulation ppp
XSR(config-if)#ppp peer default ip address 10.10.10.1
This example sets the peer’s IP address on M2P Dialer interface 2:
XSR(config)#interface dialer 2 multi-point
XSR(config-if)#encapsulation ppp
XSR(config-if)#dialer map ip 20.20.20.1 9051234567
ppp quality
This command sets the minimum Link Quality Monitoring (LQM) value on a serial interface
before the link will go down.
Percentages are calculated for both incoming and outgoing directions. The outgoing quality is
calculated by comparing the total number of packets and bytes sent to the total number of packets
and bytes received by the destination node. The incoming quality is calculated by comparing the
total number of packets and bytes received to the total number of packets and bytes sent by the
destination node.
If the link quality percentage is not maintained, the link is considered of poor quality and taken
down (by sending a DOWN event to all active NCPs). LQM forces a time lag so the link does not
bounce up and down.
Syntax
ppp quality [percentage]
ip address IP address of the remote peer.
percentage Sets the link quality threshold, ranging from 1 to 100.