Verilink 9000 Series (34-00271) Product Manual - Manual (Page 98)

76 C HAPTER 4: NMCS
Using NMCS to
Download Firmware
If the NMCS Host port is not defined, put the MultiPro unit into Default
Configuration Mode and Port 3 becomes the poll/select host port. As for the
NMCS configuration file definition, only a skeleton configuration that defines the
Global Screen is needed and the Line Module Type and Firmware version fields on
the Line module screen are used for firmware downloading. As shown in
Figure 4-23, this configuration number is 9999.
On the Line Module screen (Figure 4-24), all the ports are undefined to point out
that this application is not downloaded, but only used for downloading firmware.
Again, only the Line Module Type and Firmware Version fields on the Line
module screen are used for downloading firmware.
TXPORT INTELLINET Configuration Program
Configuration 9999
Global Parameters
Configuration Title [Skeleton Configuration ]
Down Load Station Address [00]
Com Port Speed [38400]
Phoenix Model [PDC9200]
Number of Ports on Unit [06]
Firmware Version [6.01 ]
Network Unit Number [000 ]
Power Supply Serial Number [ ]
Chassis Serial Number [ ]
Console Password [ ]
COM Port [1]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 4-23 NMCS Global Screen Configuration File Definition
TXPORT INTELLINET Configuration Program
Configuration 9999 Skeleton Config
Line Module Parameters
Line Module [01]
Copy Line Module Parameters from Configuration [ ] Line Module [ ]
Serial Number [ ] Network Host [NMCS ]
Connect Timeout (sec) [ 30] Task to Task Timeout (sec) [ 15]
Task to Terminal/Host Timeout (sec) [ 30]
Connect Command (6 char) [CONN ] Disconnect Command (6 char) [DISC ]
Send Command (6 char) [SEND ] Reserve Command (6 char) [RESV ]
Disconnect Message (24 char) [DISCONNECT ]
Port Type Description Port Type Description
1 [13] Frame Relay 2 [99] Undefined
3 [02] P/S Host 4 [14] Bisync Term
D [00] Console L [99] Undefined
Line Module Type [9000] Firmware Version [6.01 ]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 4-24 Line Module Screen with All the Ports Undefined