Verilink 9000 Series (34-00271) Product Manual - Manual (Page 313)

NMCS Screens 291
NMCS
Screens Access the IP Router from the Internetworking Applications screen (this is found
in the NMCS chapter of the MultiPRO Series manual). If the IP Router is
configured, the IP layer must be configured in the IP Router menus and the UDP
does not have to be configured later.
IP Router
Parameters
TXPORT INTELLINET Configuration Program
Configuration
Internetworking Applications
Line Module [ ]
Application Status Modify
Bridge Not Configured [ ]
IP Layer Not Configured [ ] Not used with IP ROUTER
UDP Layer Not Configured [ ] Not used with IP ROUTER
SNMP Layer Not Configured [ ]
IP PAD Not Configured [ ]
Boundary routing Not Configured [ ]
Virtual Stack Not Configured [ ]
IP Router Configured [Y]
IPX Router Not Configured [ ]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 18-1 Internetworking Applications Screen
TXPORT INTELLINET Configuration Program
Configuration
IP ROUTER parameters
Line Module [1]
Copy Parameters from Configuration [ ] Module [ ]
Enable IP Stack Only [N] Enable RIP [1]
Enable OSPF [N] Enable Trusted Neighbors [N]
OSPF Router ID [ ].[ ].[ ].[ ]
Circuit Configuration menu [ ] Other parameters menu [ ]
IP Parameters
Check Spoofing [N] ARP Time To Live (sec) [ 360]
IP Time To Live (min) [ 30] IP Forwarding [Y]
RIP Parameters
RIP Intervals (sec) [ 30] RIP Import Metric [ 8]
RIP Domain [ 0]
CLear IP ROUTER application [ ]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 18-2 IP Router Parameters Screen