Verilink 9000 Series (34-00271) Product Manual - Manual (Page 179)

Configuration / Operation 157
F. Station Not Pollable. This address is not polled after it has connected to the host.
This is an output-only device.
G. This option is not used.
H. Keep Message. When set to Y, the unit keeps a message for a station until it is
delivered or the unit is reset. Normally, output is flushed if the station goes offline.
See page 173 for further information.
I. Wait for Host Connection. When set to Y, the unit stops polling the station if the
host to which it is connected has gone offline. It is not polled again until the host
is marked on-line. The normal setting is N. See page 173 for further information.