Verilink 9000 Series (34-00271) Product Manual - Manual (Page 68)

46 C HAPTER 4: NMCS
Upgrade Software (Shift+F10)
This option permits upgrading the network controller software. When Shift+F10 is
pressed, a screen similar to the one shown in Figure 4-3 appears.
Configuration Number. Enter the configuration number of the unit requiring the
firmware upgrade.
Configuration Name. Enter the configuration name from the description field of the
configuration to be accessed. This is used as an alternate to the configuration
number.
Line Module. This field indicates the number of the line module on the unit to be
upgraded. This is always 1 for the MultiPro unit.
Upgrade File Name. This field indicates the file name of the software to be loaded.
This is an .INI file.
Cancel Software Upgrade. Entering a Y sends a cancel upgrade command to the
unit.
Get Software version. When set to Y, the unit returns the list of installed software
along with the version numbers.
Function Keys for Upgrade Software
ESC=Main. Returns to the main menu.
F1=Help. Displays a help screen relative to the current field.
F10=Send. Executes a software load. For more details on upgrading, see page 76.
TXPORT INTELLINET Configuration Program
Network Controller Software Upgrade Menu
Configuration No. [1000] Configuration Name [ ]
Line Module [ ] Upgrade File Name [ ]
Cancel Software Upgrade [ ]
Get Software version [ ]
ESC=Main F1=Help F10=Send
Figure 4-3 Upgrade Software Screen