Verilink 9000 Series (34-00271) Product Manual - Manual (Page 155)

Configuration / Operation 133
Configuration
/ Operation
NCR Terminal
Defaults are shown underlined.
Line Module
This field indicates the line module number of the displayed port. Entering a
different line module number and pressing F10 transfers the screen to the same
port on the new line module.
Port
The port field indicates the number of the displayed port. A different port may be
selected by entering its number here and pressing F10.
Description
This is a free-form field intended to describe the location or department this port services.
Copy Port Parameters
The three fields on this line work together to allow copying an existing port
configuration to the current port.
Configuration. Enter the configuration number where the stations to be copied reside.
Module. This parameter represents the line module number in the source unit.
Port. Enter the port number where the source stations reside.
TXPORT INTELLINET Configuration Program
Configuration 1000
NCR Terminal Port Parameters
Line Module [01] Port [4] Description [NCR Terminal ]
Copy Port Parameters from Configuration [ ] Module [ ] Port [ ]
Baud Rate [ 9600] Bits per Character (7/8) [7]
Parity (O/E/N) [E] Message Buffer [4096]
Interface (A/V) [A] Timeouts to Mark Offline [ 3]
Termination (DCE/DTE) (9200 only) [DCE] Offline Delay Retry (sec) [ 30]
Trailing Pads (0/1/2) [0] Maximum Selects before Poll [ 1]
Turnaround Delay (ms) [ 0] Select Retry Delay [ 10]
RTS/CTS Control (O/D/F) [D]
Drop DTR if DCD Drops (Y/N) [N]
Message Timeout (ms) [ 500]
Active if DSR/DCD (B/S/N) [S]
Poll & Select Timeout (ms) [ 300]
Activity Timeout (min) [ 0]
Limited Select Count [ 10]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 8-2 NCR Terminal Screen
✍