Verilink 9000 Series (34-00271) Product Manual - Manual (Page 46)

24 C HAPTER 2: I NSTALLATION
9111
Connections Figure 2-4 shows the rear panels of the 9111, including the power connector; reset
button; Ethernet connector and LEDs; supervisory connector; and connectors for
ports 1 through 4.
Power Connect the power supply [shown on page 20 (AC to DC) and page 21 (DC to
DC)] to the 9111. This applies power to the unit.
Supervisory
Port
The Supervisory port allows local, direct
connection of the unit to a dumb terminal or a
PC running a terminal emulation program
using the 9-9100-006-2 adapter and
9-1544-619-010 Supervisory cable. The form
factor of the connector is an RJ-48. Table 2-6
shows the pinout.
For remote applications, the Supervisory port
can also be connected to a modem using the
9-1544-619-010 cable and a 9-9100-005-1
adapter.
Ethernet Port
Table 2-7 shows the pinout of the Ethernet port.
Indicators
The Ethernet LED
indicators are located to the
right of the Ethernet
connector. Table 2-8 shows
how to interpret them.
Table 2-6 Supervisory Port Pinout
Pin Signal
1 DTE Ready (DTR)
2 Clear to Send (CTS)
3 Signal Ground (SG)
4 Receive Data (RXD)
5 Transmit Data (TXD)
6 Frame Ground
7 Request to Send (RTS)
8 Data Set Ready (DSR)
Table 2-7 Ethernet Port Pinout
Pin Signal
1 Data Out (+)
2 Data Out (-)
3 Data In (+)
4, 5, 7, 8 not used
6 Data In (-)
Table 2-8 Ethernet LED Interpretation
Indicator Interpretation
TXD The Ethernet port is transmitting data.
RXD The Ethernet port is receiving data.
LINK The unit is physically linked to a network.
COL There is a data collision.
PWR
RESET
ETHERNET
SUPERVISORY
1 3 5 7 9 11
2 4 6 8 10 12
T1
PORT 2 PORT 3 PORT 4
TXD RXD LINK COL
ON
1 2 3 4 5 6 7 8 9 10 11 12
Figure 2-4 9111 with Port 1 T1 Option