Verilink 9000 Series (34-00271) Product Manual - Manual (Page 80)

58 C HAPTER 4: NMCS
F10=Next (Port List) The Port List screen provides a way to quickly go to the configuration of a specific
port or application. An example of the Port List screen is shown in Figure 4-11.
The Up and Down arrow keys are used to highlight the desired screen. The Right
arrow key causes the line module number to increase, while the Left arrow key
causes it to decrease. By using a combination of these keys, the desired screen
may be selected. Pressing Enter causes the program to jump to the highlighted
selection.
Global
Information concerning the Global parameters is found on page 60.
Line Module 1
Information concerning the Line Module parameters is found on page 62.
Messages
Information concerning the Line Module Message parameters is found on page 65.
Port 1-4 Parameters
Information concerning Ports 1-4 parameters is found on page 67.
Port 1-4 Address Table
Information concerning Ports 1-4 address table parameters is found on page 67.
Port D Parameters
Information concerning the supervisory port parameters is found on page 68. For a
MultiPro unit with an extra two-userports module instead of an Ethernet module,
Port D is the fifth port and the Port L is the sixth port.
Global
Line Module 1
Messages
Port 1 Port Parameters
Address Table
Port 2 Port Parameters
Address Table
Port 3 Port Parameters
Address Table
Port 4 Port Parameters
Address Table
Port D Port Parameters
Address Table
Port L Port Parameters
Address Table
Internetwork Applications
Figure 4-11 Port List Screen