Hardware operation, Configuration mode, Ardware – Verilink 9000 Series (34-00271) Product Manual User Manual
Page 59: Peration
3
H
ARDWARE
O
PERATION
Introduction
This chapter contains general operating instructions for the TXPORT MultiPro hardware.
9101, 9111,
and 9211
Front Panel
Operation
Figure 3-1 shows the 9111 front panel which has two control buttons and five LED
indicators. Table 3-2 references by number these front panel controls and indicators
and provides a brief description. The MultiPro 9111 and 9101 operate the same
way. The differences with the MultiPro 9211 are noted in Table 3-2.
Configuration
Mode
The Configuration mode restores the unit to a default configuration. For more
information regarding the Configuration mode, see 9101-, 9111-, and
9211-Specific Task Download Procedure on page 78.
DOWNLOAD CONFIG
MODE BACKUP
NET
ALARM POWER
PRISM 9111SERIES
Figure 3-1 MultiPro 9111 Front Panel Controls and Indicators
7
2
1
3
4
5
6
Table 3-1 Front Panel Controls and Indicators
Index
Control/Indicator
Function/Interpretation
1
DOWNLOAD
To enter the DOWNLOAD mode, press the RESET button, located on the rear
of the unit, while holding down the DOWNLOAD button.
2
CONFIG
To enter the CONFIG mode, press the RESET button, located on the rear of
the unit, while holding down the CONFIG button. Release the CONFIG button
when the MODE LED flashes amber.
3
MODE
Flashing Green when the unit is in Run mode.
Solid Green when the unit is malfunctioning.
Flashing Amber when the unit is in Configure mode.
Solid Amber when the unit is malfunctioning.
Solid Red when the unit is in Download mode.
4
BACKUP
(green in 9101 and 9111)
TD/RD
(green/red/amber in 9211)
On when the unit has switched from primary network connection to secondary
network connection.
Off when the unit is not in backup.
Green:
Port 1 is transmitting data.
Red:
Port 2 is receiving data.
Amber:
Port 1 is receiving and transmitting data.
5
NET (green)
On when the network port is active (DCD up, LMI good).
6
ALARM (red)
On when the unit is in an active alarm condition.
7
POWER (green)
On when power is applied to the unit.