Verilink 9000 Series (34-00271) Product Manual - Manual (Page 339)

NMCS Screens 317
NMCS
Screens Access the IPX Router from the Internetworking Applications screen (this is found
in the NMCS chapter of the MultiPRO Series manual). If the IPX Router is
configured, the IP layer must be configured in the IPX Router menus and the UDP
does not have to be configured later.
IPX ROUTER
Parameters
TXPORT INTELLINET Configuration Program
Configuration
Internetworking Applications
Line Module [ ]
Application Status Modify
Bridge Not Configured [ ]
IP Layer Not Configured [ ] Not used with IP ROUTER
UDP Layer Not Configured [ ] Not used with IP ROUTER
SNMP Layer Not Configured [ ]
IP PAD Not Configured [ ]
Boundary routing Not Configured [ ]
Virtual Stack Not Configured [ ]
IP Router Not Configured [ ]
IPX Router Configured [Y]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 19-2 Internetworking Applications Screen
TXPORT INTELLINET Configuration Program
Configuration
IPX ROUTER parameters
Line Module [ ]
Copy Parameters from Configuration [ ] Module [ ]
Enable IPX Router [Y] Enable SAP [Y]
Enable RIP [Y] Enable NLSP [N]
Enable IPXWAN2 [N] IPX Maximum Hop Count [ 16]
Circuit Configuration menu [ ] Other parameters menu [ ]
NLSP Parameters
Router Id [000000000000] Internal Network Number [ ]
Router Name [ ]
NLSP Area Network Number [ 0] NLSP Area Mask [ 0]
Broadcast HELLO Interval [ 10] Non Broadcast HELLO Int. [ 10]
Designated Router HELLO Int[ 3] Holding Time Multiplier [ 5]
CLear IPX ROUTER application [ ]
Figure 19-3 IPX Router Parameters Screen