Verilink 9000 Series (34-00271) Product Manual - Manual (Page 137)

Configuration / Operation 115
Configuration
/ Operation
Bisync Terminal Figure 7-2 shows a Bisync Terminal Port parameters screen.
Defaults are shown underlined.
Line Module
This field indicates the line module number of the port currently being displayed.
Entering a different line module number and pressing F10 transfers the program to
the same port on the new line module.
Port
The port field indicates the number of the port currently being displayed. A
different port may be selected by entering it's number here and pressing F10.
Description
This is a free-form field intended to describe the location or department this port services.
Copy Port Parameters
The three fields on this line work together to allow the user to copy an existing
port configuration to the current port.
Configuration. The number of the source configuration to copy from entered in this
field. This can be any existing configuration, current or otherwise.
Line Module. Enter the line module number of the port that is to be copied.
TXPORT INTELLINET Configuration Program
Configuration 1000
Bisync Terminal Port Parameters
Line Module [01] Port [3] Description [ ]
Copy Port Parameters from Configuration [ ] Module [ ] Port [ ]
Baud Rate [ 9600] Bits per Character (7/8) [8]
Parity (O/E/N) [N] Message Buffer [4096]
Interface (S/V) [S] Maximum Messages Queued [ 4]
Termination (DCE/DTE) (9200 only) [DCE] Timeouts to Mark Offline [ 3]
Trailing Pads (0/1/2) [1] Offline Delay Retry (sec) [ 30]
Turnaround Delay (ms) [ 10] Maximum Selects before Poll [ 1]
RTS/CTS Control (O/D/F) [D] Select Retry Delay [ 10]
Drop DTR if DCD Drops (Y/N) [N] Active if DSR/DCD (B/S/N) [5]
Message Timeout (ms) [ 3000] Activity Timeout (min) [ 0]
Poll & Select Timeout (ms) [ 3000] End to End Protocol Conversion [N]
End to End Flow Control [Y]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 7-2 Terminal Screen
✍