Verilink 9000 Series (34-00271) Product Manual - Manual (Page 76)

54 C HAPTER 4: NMCS
F4=Statistics The Statistics menu screen provides statistics information on any port of any
TXPORT unit in the network. The statistic program is initiated from the main
menu by pressing F4 when under DOS or Windows 95. When running under
Windows 3.1, this program should have its own program item. An example of the
Statistics screen is shown in Figure 4-8.
Configuration Number
This field is used to identify, by number, the configuration desired to send a
statistic request to.
Configuration Name
If it is desired to send a statistic request, but the configuration number is not
known, the user may enter a name. The program then initiates a search of the
description field of each configuration looking for a match. The program stops at
the first match found.
Statistic Type
There are several different statistic types that may be sent to a TXPORT unit.
Figure 4-9 on page 56 is an example of a typical Statistics screen. The following is
a description of each.
WAN Statistics.
(L) - LINE MODULE - This request returns specific information about the line
module itself. Included in this are firmware version, installed protocols, and
position of the run/config switch. Only the line module field needs be filled in for
this request.
TXPORT INTELLINET Configuration Program
Network Controller Statistics
Configuration No. [ ] Configuration Name [ ]
Statistic Type [ ]
Line Module [ ]
Port [ ]
Station Name [ ]
ESC=Main F1=Help F10=Send
Figure 4-8 Statistics Menu Screen