Status menu, Link status – Verilink 9000 Series (34-00271) Product Manual User Manual
Page 416
394
C
HAPTER
A: C
ONSOLE
I
NTERFACE
Enter the name of the station as it was entered when that station was configured.
When the statistics have been reset, the following is displayed.
Station statistics of TEST have been reset
Status
Menu
The STATUS MENU is normally used to diagnose problems on a port. It shows
the current status of the port, the RS-232 signals, and which stations are on-line or
offline. When 4 (Status Menu) is selected from the Main menu, the following
screen is displayed.
STATUS MENU
----------------------
L - Link status
P - Partial Link status
S - Station status
A - Address status
N - Internetwork appl. status
M - Main menu
Enter choice :
Link Status
To display information about a port (link), enter L. The following prompt is
displayed.
ENTER TARGET (unit.linemodule.link -> xxx.yy.zz) :
Enter the unit number (xxx), a period (.), the line module (yy), a period (.), and the
port number (zz) desired. A display, similar to one of the following, is generated.
Link status of 000.01.01
Link type : CONSOLE
Status:
Link state: LINK ACTIVE
Transmission: ACTIVE
Reception: READY
Physical level:
DCE/DTE: DTE
TDI : No
Clock : Normal
DTR : OFF
DSR : OFF
RTS : ON
CTS : ON
DCD : ON
Addresses on the link:
Address :
CONFIRMY
Address :
Address :
Address :
Address :
Address :
Address :
Address :
Hit a key to continue...