Verilink 9000 Series (34-00271) Product Manual - Manual (Page 133)

Console Port Parameters 111
Console
Port
Parameters Figure 6-5 is displayed when a port is selected and defined as a Console port, as
described above, or the selected port is currently defined as a Console port. The
parameter values shown are the defaults.
Each of these parameters is described in the following paragraphs.
Defaults are shown underlined.
Line
Module
This field indicates the line module number of the displayed port. Entering a
different line module number and pressing F10 transfer the program to the same
port on the new line module.
Port The port field indicates the number of the displayed port. A different port may be
selected by entering its number here and pressing F10.
Description This is a free-form field intended to describe the location or department this port
services.
Copy Port
Parameters
The three fields on this line work together to allow copying an existing port
configuration to the current port.
Configuration
The number of the source configuration to copy from is entered in this field. This
can be any existing configuration, current or otherwise.
TXPORT INTELLINET Configuration Program
Configuration 30 ASYNC APPLICATION
Asynchronous TTY Console Port Parameters
Line Module [01] Port [5] Description [Console ]
Copy Port Parameters from Configuration [ ] Module [ ] Port [ ]
Baud Rate [ AUTO] Bits per Character (7/8) [7]
Termination (DCE/DTE) (9200 only) [DCE] RTS/CTS Control (O/D/F) [D]
Parity (O/E/N) [E]
Full Duplex (Y/N) [Y]
Flow Control (X/D/C/N) [ X]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 6-5 Console Port Parameters Screen
✍