Verilink 9000 Series (34-00271) Product Manual - Manual (Page 117)

Configuration / Operation 95
Unisys
Poll/Select
Host
Each of these parameters is described in the following paragraphs.
Defaults are shown underlined.
Line Module
This field indicates the line module number of the port being displayed. Entering a
different line module number and pressing F10 transfers the screen to the same
port on the new line module.
Port
The port field indicates the number of the displayed port. A different port may be
selected by entering its number in this field and pressing F10.
Description
This is a free-form field intended to describe the location or department this port
services.
Copy Port Parameters
The three fields on this line work together to allow copying an existing port
configuration to the current port.
Configuration. Enter the configuration number where the stations to be copied
reside.
Module. This parameter represents the line module number in the source unit.
Port. Enter the port number where the source stations reside.
TXPORT INTELLINET Configuration Program
Configuration 1 Burroghs
Unisys Poll/Select Terminal Port Parameters
Line Module [01] Port [1] Description [Poll/Select Host ]
Copy Port Parameters from Configuration [ ] Module [ ] Port [ ]
Baud Rate [19200] Bits per Character (7/8) [7]
Parity (O/E/N) [E] Message Buffer [4096]
Interface (S/A/T/V) [T]
Termination (DCE/DTE) (9200 only) [DCE]
Trailing Pads (0/1/2) [0]
Turnaround Delay (ms) [ 10]
RTS/CTS Control (O/D/F) [F]
Messages per Group Poll [N]
Offline Timeout (sec) [ 500]
Upline Controller (Y/N) [N]
Host Name [ ]
Backup Host Name [ ]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 5-4 Unisys Poll/Select Host
✍