Verilink 9000 Series (34-00271) Product Manual - Manual (Page 41)

2
I
NSTALLATION
Introduction This chapter contains information and instructions required to prepare TXPORT
MultiPro platforms for use. Included are initial inspection procedures, connections,
and powering information.
The 9101, 9111, and 9211 units are shipped ready for desktop use.
Safety Summary This manual contains information and warnings which must be followed by the
user to ensure safe operation and to retain the equipment in a safe condition.
This WARNING sign denotes a potential hazard to the operator. It calls attention to a
procedure or practice which, if not correctly performed or adhered to, could result in
injury or loss of life. Do not proceed beyond a WARNING sign until the indicated conditions
are fully understood and met.
Unpacking and
Inspection This unit is carefully packaged to prevent damage in shipment. Upon receipt,
inspect the shipping container for damage. If the shipping container or cushioning
material is damaged, notify the carrier immediately and make a notation on the
delivery receipt that the container was damaged (if possible, obtain the signature
and name of the person making delivery). Retain the packaging material until the
contents of the shipment have been checked for completeness and the instrument
has been checked both mechanically and electrically.
If the contents of the shipment are incomplete or, if there is mechanical damage or
defect, notify TXPORT. If the shipping container is also damaged, or the
cushioning material shows signs of stress, notify the carrier of the damage as well
as TXPORT. Keep the shipping materials for the carrier’s inspection. TXPORT
will arrange for repair or replacement without waiting for claim settlement.
Supplied
Materials The 9101, 9111, and 9211 are shipped from the factory with the following
standard equipment:
✦ AC-to-DC power supply
✦ Supervisory cable (9-1544-619-010) and adapter (9-9100-006-2)
For specific applications, additional cables and adapters may be required for the
installation and operation of the unit. The interface requirements of any application
may be met by using the appropriate cable. Standard cables and TXPORT ordering
numbers are listed in Ordering Numbers and Optional Equipment on page 12.
Contact TXPORT for any needed assistance in cable selection.
The 9101, 9111, and 9211 MultiPro platforms may only be used with the
TXPORT-provided power supplies [p.n. 24-00108 (AC to DC) and p.n. 9-9100-028-1
(DC to DC)]. ✍