Verilink 9000 Series (34-00271) Product Manual - Manual (Page 304)

282 C HAPTER 17: B RIDGE
LAN Remote
Bridge List
Remote Bridge Name
The Remote Bridge Name parameter specifies the name of the remote bridge. Up
to 17 characters may be used.
Port Number
The Port Number parameter specifies the number of the remote bridge link. The
selections are 2 to 15 and the default is 0.
Type
The Remote Bridge Type parameter specifies the type of the remote bridge. The
only type currently supported is PDC.
WAN Path Cost
The WAN Path Cost parameter is used in the spanning tree algorithm to quantify
the efficiency path of the WAN. The selections are 1 to 65535 Mbps. The default
is 667.
LAN Options
Option A - Flush Frame With Unknown Destination. Setting this option prevents the
port from forwarding a frame if the address does not exist on the LAN attached to
this port. A port does not send data to a remote destination if the remote
destination did not yet send a message.
TXPORT INTELLINET Configuration Program
Configuration 1000
Remote bridge list parameters
Line Module [1]
Copy remote Bridge Parameters from Configuration [ ] Module [ ]
Name Port number Type WAN path cost Options
ABCDEFG
002LAN 1 PDC 667 NNNN
005LAN 1 PDC 667 NNNN
F1=Hlp F2=Mod F3=Add F4=List F5=Clr F6=DelAll F7=Copy F8=Jmp F9=Prev F10=Next
Figure 17-3 LAN Remote Bridge