Verilink 9000 Series (34-00271) Product Manual - Manual (Page 180)

158 C HAPTER 9: U NISYS U NISCOPE
Uniscope
Host
Line Module
This field indicates the line module number of the port being displayed. Entering a
different line module number and pressing F10 transfers the screen to the same
port on the new line module.
Port
The port field indicates the number of the displayed port. A different port may be
selected by entering its number in this field and pressing F10.
Description
This is a free-form field intended to describe the location or department this port
services.
Copy Port Parameters
The three fields on this line work together to allow copying an existing port
configuration to the current port.
Configuration. Enter the configuration number where the stations to be copied
reside.
Module. This parameter represents the line module number in the source unit.
Port. Enter the port number where the source stations reside.
After these fields have been filled, press F10. This re-displays the port using the
copied values.
TXPORT INTELLINET Configuration Program
Configuration 1000
Sperry Host Port Parameters
Line Module [01] Port [3] Description [Sperry Host ]
Copy Port Parameters from Configuration [ ] Module [ ] Port [ ]
Baud Rate [ 9600] Bits per Character (7/8) [7]
Parity (O/E/N) [O] Message Buffer [4096]
Interface (S/A/V/T) [S] Offline Timeout (sec) [ 30]
Termination (DCE/DTE) (9200 only) [DCE] Host Response Timeout (sec) [ 3]
Trailing Pads (0/1/2) [2] Maximum Messages Queued [32]
Turnaround Delay (ms) [010] Acknowledgment Passing (Y/N) [Y]
RTS/CTS Control (O/D/F) [D] Backup Host Name [ ]
Host Name [SPERRY ] End to End Protocol Conversion [Y]
End to End Flow Control [N]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 9-4 Uniscope Host Screen
✍