Verilink 9000 Series (34-00271) Product Manual - Manual (Page 124)

102 C HAPTER 6: A SYNCHRONOUS H OST AND T ERMINAL P ROTOCOL P ARAMETERS
Asynchronous
Terminal
Parameters
Each of these parameters is described in the following paragraphs.
Defaults are shown underlined.
Line Module This field indicates the line module number of the displayed port. Entering a
different line module number and pressing F10 transfers the program to the same
port on the new line module.
Port The port field indicates the number of the displayed port. A different port may be
selected by entering its number here and pressing F10.
Description This is a free-form field intended to describe the location or department this port
services.
Copy Port
Parameters
The three fields on this line work together to allow copying an existing port
configuration to the current port.
Configuration
The number of the source configuration to copy from is entered in this field. This
can be any existing configuration, current or otherwise.
Line Module
Enter the line module number of the port to be copied.
TXPORT INTELLINET Configuration Program
Configuration 1000
Asynchronous TTY Terminal Port Parameters (Part 1)
Line Module [01] Port [1] Description [ ]
Copy Port Parameters from Configuration [ ] Module [ ] Port [ ]
Baud Rate [ 9600] Bits per Character (7/8) [7]
Parity (O/E/N) [E] Message Buffer [4096]
Transparent Mode (Y/N) [N] Host Type [ 0]
RTS/CTS Control (O/D/F) [D] Terminal Type [ 0]
Drop DTR if DCD Drops (Y/N) [N] Device Type (H/T) [T]
Active if DSR/DCD (B/S/N) [S] Alternate Port [ ]
Full Duplex (Y/N) [Y] User Field Length [ 20]
Flow Control (X/D/C/N) [ XD] Suppress Trailing Blanks [N]
Input Terminator (C/L/T/U) [C] End of User Field [<]
User Terminator (HEX Code) [ ] Output Terminator (B/C/L/E/N) [N]
Include Terminators (Y/N) [N] Inactivity Timer [ 0]
Input Terminator Timeout (ms) [ 100] Termination (DCE/DTE) (9200) [DCE]
ESC=Main Menu F1=Help F5=Clear F7=Redisplay F8=Jump F9=Previous F10=Next
Figure 6-2 Asynchronous Terminal Configuration Parameters
✍