Verilink 9000 Series (34-00271) Product Manual - Manual (Page 374)

352 C HAPTER 20: S IMPLE IP/IPX R OUTER C ONFIGURATION S CENARIO U SING NMCS S CREENS AND RFC-1490
Figure 20-32 Press 10 to go to the Application
TXPORT INTELLINET Configuration Program
Configuration
IPX ROUTER parameters
Line Module [ ]
Copy Parameters from Configuration [ ] Module [ ]
Enable IPX Router [Y] Enable SAP [Y]
Enable RIP [1] Enable NLSP [N]
Enable IPXWAN2 [N] IPX Maximum Hop Count [ 16]
Circuit Configuration menu [ ] Other parameters menu [ ]
NLSP Parameters
Router Id [ ] Internal Network Number [ ]
Router Name [TXPORT Router 001 ]
NLSP Area Network Number [ 0] NLSP Area Mask [ 0]
Broadcast HELLO Interval [ 10] Non Broadcast HELLO Int. [ 10]
Designated Router HELLO Int[ 3] Holding Time Multiplier [ 5]
CLear IPX ROUTER application [ ]
TXPORT INTELLINET Configuration Program
Configuration
Internetworking Applications
Line Module [ ]
Application Status Modify
Bridge [ ]
IP Layer [ ] Not used with IP ROUTER
UDP Layer [ ] Not used with IP ROUTER
SNMP Layer [ ]
IP PAD [ ]
Boundary Routing [ ]
Virtual Stack [ ]
IP Router [Y]
IPX Router [ ]
Figure 20-33 Enter Y in the Modify Field of the IP Router