Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 999)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 983
5.6.4.13 MEAS Spec
5.6.4.13.1 MEAS Spec - Overview
Dialog window: Method ▶ MEAS Spec ▶ Properties... ▶ MEAS Spec - 'Command
name'
Command for the Measurement of the sample spectrum.
Devices
This command can be executed with the following device:
Spectrometer: Avantes
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Spec are configured on the fol-
lowing 3 tabs:
￭ General/Hardware
Parameters for device.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluations
Definition of evaluation results for the sample spectrum.
Command variables
The following command variables are generated in the method run by the
command MEAS Spec and can be used in formulas under the designation
'Command name.Variable designation':
Identification Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has not ever been started
.DBL Total duration for the processing of the command in s
.FIN Command status; 1 = Command has been ended
at least once, 0, invalid (variable not available) =
Command has never been ended
.STY Type of stop with which the command was stopped:
1 = normal;0 = manual or after error