Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1182)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1166 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
5.6.9.4.3 SEND - Send event message
Dialog window: Method ▶ SEND ▶ Properties... ▶ [New]/ [Properties] ▶ Send event
message
Recipient
Selection of the type of recipient.
Selection System | Command
Default value System
Selection
Selection of the recipient address. All of the command names already
defined in the method are available for Recipient Command. This field is
empty and cannot be edited for Recipient System.
Selection 'Command name' | 'empty'
Default value 'empty'
Event message
Selection of the event message to be sent. The following event messages
can be selected depending on the type of recipient:
System
Selection
Quit | Hold | Stop
Default value Quit
Command
Selection
Quit | Hold | Continue | Start Titration
Default value Quit
Recipi-
ent
Selec-
tion
Event
mes-
sage
Significance
System - Hold Hold determination (all tracks). This
corresponds to the [Hold] button in
the dialog window Run in the pro-
gram part Workplace.
System - Quit Cancel determination (Series contin-
ues).
System - Stop Stop determination and series. This
corresponds to the [Stop] button in
the dialog window Run in the pro-
gram part Workplace.