Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1320)

6.6 Subwindow Titrants/Solutions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1304 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Tubing parameters
Defines the length and diameter of the tubing connected to the dosing unit.
The port assignment can also be altered. These parameters are important
for carrying out the dosing unit commands PREP and EMPTY correctly, as
the volumes of the tubing connections have to be taken into account.
Note
Default values have already been entered for the tubing parameters; these
correspond to the dimensions of the standard tubing supplied. If you do
not make any alterations to the tubing connections then you do not need
to modify the tubing parameters. For information on length and diameter
of other tubings see Products/Accessories and columns under
http://
products.metrohm.com .
Dosing port 1
Port
Port to be used as Dosing port 1.
Selection Port 1 | Port 2 | Port 3 | Port 4
Default value Port 1
Length
Length of tubing attached to Dosing port 1.
Range 0.0 ... 999.9 cm
Default value 40.0 cm
Diameter
Diameter of tubing attached to Dosing port 1.
Range 0.0 ... 9.9 mm
Default value 2.0 mm
Dosing port 2
Port
Port to be used as Dosing port 2.
Selection Port 1 | Port 2 | Port 3 | Port 4
Default value Port 3
Length
Length of tubing attached to Dosing port 2.