Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 591)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 575
.MA.MEA Maximum measured value in the unit of the measured
value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MA.VOL Volume with maximum measured value in mL
.MI.MEA Minimum measured value in the unit of the measured
value
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MI.VOL Volume for minimum measured value in mL
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in the measuring point list
.SLO Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.SME Start measured value (measured value after processing
the start conditions) in the unit of the measured value
.STE Start temperature (temperature after processing of the
start conditions) in °C
.STY Type of stop with which the command was stopped:
1 = normal;0 = manual or after error
.SVA Start volume absolute (volume that was added accord-
ing to the start condition "start volume") in mL
.SVM Start volume measured value (volume which was added
according to the start measured value given in the start
conditions) in mL
.SVS Start volume slope (volume that was added according
to the start condition "start slope") in mL
.SVT Total start volume (volume that was added in depend-
ence on all three start conditions) in mL
.TITER Titer value of the solution used for the command