Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1481)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1465
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Terminator for receiving
Final character for receiving in hexadecimal code.
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Code page
Code page used for the data transfer.
Selection Cp437 | Cp850 | Cp852 | ASCII
Default value Cp437
Sending characters separately
on | off (Default value: off)
If this option is enabled each character is sent separately. The delay time is
allowed to run before sending the next character.
Delay time
Delay time until the sending of the next character.
Range
0 ... 9999 ms
Default value 0 ms
[Connect]
Establishes the connection to the RS-232 device. The dialog window Estab-
lish connection appears (see Chapter 7.16.5, page 1467).
[Disconnect]
Disconnects the connection to the RS-232 device (only then the device can
be deleted out of the configuration).
7.16.4 Properties - GLP
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ 'Properties - 'Device type' -
'Device name' ▶ GLP
GLP test date
Date of the last GLP test. This date can be selected by clicking on in the
dialog window Select date (see Chapter 2.5.1, page 83).
Comment GLP test
Comment on GLP test.