Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1466)

7.14 874 Oven Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1450 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
7.14.3 Properties - Tower
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Tower
On the tab Tower the tower parameters for the tower on the 874 Oven
Sample Processor are edited.
Max. stroke path
Entry of the lowest permitted lift position for the tower. A lift height of 0
mm corresponds to the "Home position", i.e. the lift is moved right to the
top.
Range 0 ... 110 mm
Default value 110 mm
Lift rate
Entry of the lift rate for manual control of the tower.
Range 3 ... 25 mm/s
Default value 25 mm/s
7.14.4 Properties - Rack
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Rack
On the tab Rack the rack-specific data of the attached rack are shown.
Rack name
Shows the name of the rack attached. If no rack is in position then "-----" is
shown.
Rack code
Shows the rack code of the rack attached. The rack code corresponds to the
arrangement of magnets on the base of the rack and is read in by the Sample
Processor in order to recognize the rack. If no rack is in position then the
display will be empty.
Number of positions
Shows the number of positions on the rack. If no rack is in position then the
display will be empty.
Shift rate
Sample rack speed of rotation for manual operation.
Range 3 ... 20 °/s
Default value 20 °/s