Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 997)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 981
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has not
ever been started
.DBL Total duration for the processing of the command in s
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Command
has never been ended
.STY Type of stop with which the command was stopped: 1 =
normal;0 = manual or after error
5.6.4.12.2 MEAS Ref - General/Hardware
Tab: Method ▶ MEAS Ref ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Avantes Spectrometer
Default value Avantes Spectrometer