Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1529)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual Control
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1513
Note
For viscous liquids the filling rate should be reduced.
Selection maximum
Default value maximum
Titrando, 814, 815, 855
Range
0.01 ... 166.00 mL/min
778, 789
Range
0.01 ... 160.00 mL/min
[Dosing]
Start manual dosing for the selected dosing device. Dosing will take place
as long as the button is pressed down. The dosed volume is displayed live.
Note
Parameters modified after the start of the dosing are not valid until the
next dosing procedure.
[Fill]
Start filling of the buret for the selected dosing device. During the filling
procedure the volume display is set to 0.0000 mL.
8.4.2 Stirring
8.4.2.1 Stirring - Overview
Program part: Manual Control
If in the subwindow for the device selection (see Chapter 8.3, page 1507),
a Stirrer connected via MSB or stirrer connector is selected, then the func-
tions and parameters belonging to the stirrers are displayed in the sub-
window Functions/Parameters.
Stirrer functions
The stirrer functions are displayed on the following tabs:
￭ Switch on/off
￭ Continuous operation
Devices
The stirrer functions can be carried out with stirrers that are connected to
the following devices: